ZCar Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Read Only
Joined
·
3,883 Posts
Discussion Starter #1
i have a 72 that well needs a new body which im going to get very soon. now for the engine its been bored .30 over, which is good enough for me. im wanting a little more and what i was thinking is since i have a good cam 460 lift 270/280 duration, is getting a port and polish, bigger valves, tri angle valve job, and maybe a shave for it. my main question is what would be the best intake and exhaust valve sizes to go with for this setup with a set of triple 40mm DHLA dellortos.. any ideas?\

thanks james
pittsburgh pa
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top