ZCar Forum banner

Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
i am insterested in picture or some kind of wiring diagram for L28 turbo engine management system. The problem i face is when i purchased the motor to put into my Patrol, the ignition side of the wiring lume was partical cut out of cars wiring lume and was foriegn to previous car. The Distributor has two plugs, one goes to the coil and other somehow goes to the Noc Sensor but i am not sure how. Also i can not find the negitive to the coil. As you can see i am in a bit of trouble. PLEASE IF U HAVE ANY INFO FOR ME, PLEASE CALL ME ON:
0438 076 157

Greatly Appreciated

Chris
 

·
Registered
Joined
·
532 Posts
If you can get hold of a Haynes manual for '79-'83 Datsun 280ZX, there is a pretty good wiring diagram in it. Let me know if you need the info on how to hook up the 280ZXT wiring to make it work. I have a list of what wires need power, ign signal, etc. I can email it to you.

Ian
 

·
Registered
Joined
·
11,803 Posts
I'm looking at a turbo into a 240 for myself too. Can you also E-mail the wire list to me, or just post it on this site for everyone

Thanks!!
 

·
Registered
Joined
·
231 Posts
Me too please!!! tks
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top