ZCar Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
109 Posts
Discussion Starter #1
is it ok to set my jack stands under the cross-member?
cause every where else it seems that the weight of the car is bending something under there?
where should I put my jack stands?
thanks for your input, oh yeah this is a virtually rust free (underneath) car. (1979 2+2 280zx)
 

·
Registered
Joined
·
905 Posts
When I had mine up for storage while engine was being built, I had the front stands on the crossmember under the engine on the outer edge towards the frame rails. The rear stands were on the sub-frame near the sway bar mounts.
Hope this helps.
 

·
Registered
Joined
·
771 Posts
i dont know if i do it correctly but, i always use a block of wood and place a jack or jack stands under a part of the suspention. i never jack it up or place jack stands under the body. simply because i already replaced most of it and i dont want it dented up!
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top