ZCar Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
767 Posts
Discussion Starter #1
Where do you guys lift your 280zx's from, using a hydraulic jack?

Where do you put the jack stands?

The frame rails on these cars tend to crush.
 

·
Registered
Joined
·
7,639 Posts
1)Front crossmember under the engine. Use a 1/2" thick block.
2)Rear at the bolt on the front attach point of the rear suspension member(it's dished and is perfect for a hudraulic floor jack wiythout a block).

I use ramps under the car in case things fall. They are WIDE and will not tip over.

-mark
 

·
Registered
Joined
·
5,829 Posts
I use the front cross member, and place the jack stands between the control arms and the cross member. On the rear I use the diff housing to jack up the car, and then use jack stands on the outer trailing arm location on the cross member.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top