ZCar Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
655 Posts
Discussion Starter #1
I have an 83 n/a I replaced all the front bushings except the stabilize bar. How tight are you supposed to tighten the end links and strut bushings? Also it seems that the steering wheel is now off a little did I dramitacally effect the alignmant? If so is there a quick check?
 

·
Registered
Joined
·
2,156 Posts
you toe sounds like its been changed. ide suggest a front end alignment
anytime you do extensive front end work like replacing all the bushings

you probably should have a torque wrench torque to the factory specs
unless of course these are urethane bushings. if they are ide suggest
searching zcar.com for urethane bushings to see if torque specs change
for the urethane
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top