ZCar Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
1,071 Posts
Discussion Starter #1
To put it simple, my lower ball joints are fuct on the front. I talked to Coz and you have to buy the control arm (which comes w/ the ball joint). Now my question is, how easy or how hard is it to replace the control arms with ball joints? The mechanic I was talking to today said it would be easier changing out the whole unit rather than just changing out the ball joint.

Also, are there any special tools required for completing this task?
 

·
Registered
Joined
·
4,353 Posts
Actually NAPA .....

has ball joints for the control arms. Now the ball joints need to be pressed out of the old control arms and the new ones pressed in. That can be tricky as the control arm can be bent if it is not done right.
MaxDoc
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top