ZCar Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
538 Posts
Discussion Starter · #1 ·
If you have a 1981 280 zx with ignition module that attaches to the distribuitor and it is a 2 prong exposed type would you remove your dist. cap and rotor and measure the red and green wires and tell me what ohms reading you get I think mine is bad. I am getting a 292
kilo ohms reading and difficult to start at times. Haynes manuel says 400 kilo ohms but I have read in this forum that that particular manuel is not always accurate
 

·
Registered
Joined
·
3,550 Posts
I have an 82 that I replaced the dist in. I still have the dist and module if you think any of these readings would apply, I'll be glad to check it when I get home tonight.

Ken
 

·
Registered
Joined
·
417 Posts
I can't give u the spec. but I have a question for you does you care ever just cut off after it warms up.
also I found out that I had a bad connection on my moduel and it had a hard time starting after I fixet that it start right up.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top