ZCar Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
38 Posts
Discussion Starter #1
What is the favored replacement ignition coil here at Zcar.com? I have replacements to make, and I was thinking about the MSD Blaster 2. Any advice?
 

·
Registered
Joined
·
602 Posts
Couple a coil questions...

1. I put a PS20 on a few weeks ago. The instructions were somewhat vague. Do I need to install the ceramic resistor block that comes with it? My 77 already has a larger block below the coil. I went ahead and put it in best according to the sheet, and the car runs great, but is it necessary?

2. I am really planning on a 6A or 6AL in the near future. When I do so, will I have to upgrade the coil? I am already kicking myself--the PS91 is only $59 and I paid nearly 40 for the little PS20.

steve 77
 

·
Registered
Joined
·
887 Posts
Re: Couple a coil questions...

just remove the one it came with and use the one the car allready has,Its called a ballist resistor,and if you dont use one you'll go through points like mad or youll blow the ignition module.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top