ZCar Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter · #1 ·
I am rebuilding my 240Z front end, I replaced the ball joints and now I need help setting the steering knuckles.

I know they press fit on, but how do you center them?

Any help appreciated.

Mark
 

·
Registered
Joined
·
3,207 Posts
Hi Marcclass5.
Am not sure I understand what you are asking here..... the steering knuckles on Z's are bolted into place and not pressed fit. Perhaps you will need to WD 'em and use rust petroleum remover as well. shane-
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top