ZCar Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
107,695 Posts
Discussion Starter #1
Has anyone purchased this book How to Modify Datsun OHC engine . As you may know I am doing up an 81 zxt motor, I was wondering if the book focuses more on head shaving increasing compression ratio or does it have general good stuff like balancing head porting .... Your input is always valued . If you guys would like to discuss any tips and tricks when rebuilding.
Here are some of mine.
1) Port Match manifolds to head
2) Port match intake to throttle body
3) File smooth the header when installing
4) To remove pilot bushing squirt in axle grease and use a round punch a tad smaller then pound it with a hammer it pops right out .
5) Antiseize all exterior bolts.
6) Remeber to reindex cam
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top