ZCar Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
715 Posts
Discussion Starter · #1 ·
I have a crane hi-6 and cant get my autometer tach to work. Does anyone know how to hook it up right? Can the output for the tach on the hi-6 be bad? it only has 650 miles on it and i never hooked a tach up to it before.


Thanks- Evan
 

·
Registered
Joined
·
107,695 Posts
You need a tach adapter from Crane

I tried the same thing with mine and it wouldnt work. They (crane tech support) said it required a tach adapter. I wanted a cheap tach and the cost of the adapter and tach was higher than I wanted so I returned it instead. Holding out for a good one. I think I'm going to put a 5 inch tach in the hole for the factory tach eventually, just have to figure out what to do for turn signals. Guys in my Z club say they just listen for the clicking sound, but I dont think its loud enough. Now, If I wired in buzzers in place of the lights.......

Good Luck
Mike
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top