ZCar Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

· Registered
Joined
·
383 Posts
Discussion Starter · #1 ·
Very basic question..

I removed my plug cables and my #6 labeled cable will not reach the #6 plug.When I look at the FMS as what is the #6 on the distributor it will not reach.

I know I am doing something incorrect with regard to the distributor so any advice will be very welcome.

Thanks, Steve.
 

· Registered
Joined
·
1,298 Posts
If the car ran, and ran correctly BEFORE you removed the wires, then the only thing you need to look at is if you changed the position of the wire loom, or are running the wires differently than they were originally, or if you rotated the distributor cap (pretty hard to do, unless you're 180° off), or if you put the wrong spark plug wire in the first hole and went around in the right sequence, just one or two holes off.

Basically, retrace your steps if in fact you are replacing the wires that WERE on the car. If they are new wires, then all I can think of is that you put them on the wrong spot on the cap, or that the labels are in error.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top