1/4" pipe
Help stonehenge69
Do you know the dimensions of the threaded pipe plugs you used on your stroker engine??? or where I can get them???
Thanks
Rob
Thanks
Rob
- Status
- Not open for further replies.
1 - 5 of 5 Posts
Don't forget.......the front plug will need to be shortened so that it doesn't close off the #1 main bearing oil passage and, at the same time fit flush with the front face of the block.
Post Edited (Nov 10, 2:53am)
Post Edited (Nov 10, 2:53am)
How short do I need to make it?? Or is it easy to figure out by looking at it.
Thanks, for all the info......
Rob
Thanks, for all the info......
Rob
Measure depth to back and thickness of wall after plugs are are removed.
1 - 5 of 5 Posts
- Status
- Not open for further replies.
ZCar Forum
A forum community dedicated to Nissan and Datsun Z car owners and enthusiasts. Come join the discussion about performance, modifications, restorations, troubleshooting, maintenance, and more!
Full Forum Listing
