ZCar Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #1 ·
Yesterday, I swapped out the original 240 tranny with (I was told a 260Z 4-speed). The problem is that the shifter is now too far forward and is hitting the body panel opening. I have always heard that the 4-speeds all are exchangeable and only the 5-speed had this problem. The drive shaft appeared to fit ok but since the overall tranny is a little bit shorter, is this a problem too. I think there are enough of the splines from the drive shaft that are making contact (if you know what I mean).

I would appreciate any thoughts from this most knowledgeable group. Thanks.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top