ZCar Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #1 ·
I got a stainless steel 3-into-2-into-1 header as part of the deal on my ex-racer. Can anyone tell me what make it is and if it's any good? I figure because it's stainless, it must be pretty rare, expensive hence good?

The car's drivetrain will come from my 76Z with built L28. To make the job easier, I've decided to go with early Z carbs. Is this the way to go? Will I lose any performance doing this?

Thanks!
 

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #3 ·
RE: square or round port?

Square. It was surprisingly rough inside the ports where the tubes are welded to the flange.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top