ZCar Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
1,071 Posts
Discussion Starter #1
I am probably going ot have Dave change the upper/lower intake gaskets. Coz just gave me thep rice for the plenum gasket? I am sure there are more gaskets I should buy to have this little project done, correct?

If so, can someone give me a list of gaskets I will need, or things that could be done while doing this?
 

·
Registered
Joined
·
4,300 Posts
I would suggest the TB gaskets and the Iddle Screw unit gasket just in case and if your plenum is coming out might aswell over pass the TB water hoses and if your lower intake is coming out aswell go for the knock sensor replacement just like maintnance other than that youre fine....

oh keep the pcv's in mind as well I changed them when I had to take out my plenum
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top