ZCar Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
1,299 Posts
Discussion Starter · #1 ·
i am rebulding a 83 280zxt. i stripped everything off and out of the car to get the body work done and paint the engine bay. got it back from paint have all the wiring harnesses in, dash, engine, and everything hooked back up, but the lights. i tried to start it will turn over fine but fuel pump isnt getting an electricity? checked the lights, they all work dash lights fuel gauge all work. any body have an idea what i am doing wrong???
 

·
Registered
Joined
·
287 Posts
Start by checking for power in the following order
1. Pump harness disconnect plug in trunk area under carpet - If you have power there its the line going to the pump terminals. No power there work back to -
2. Fuel pump relay. Located behind side kick panel on passenger side. Remove glove box liner to get to it.
Good luck
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top