ZCar Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
Ok, here's the situation: My engine ran fine in the donor car (a 76 280Z), but since I put it into a 77 280Z, I can't get it to run. I have changed out the computer and wiring harness. The latest development is that if I disconnect the wiring harness from the computer and cross the hot wire and ground wire (bypassing the computer) I can get the injectors to run, but I can get the injectors to run throught the computer. Anyone got any ideas about what to do next?
 

·
Registered
Joined
·
63 Posts
check your ignition relay located under the dash
on the passenger side. The reason I say this I had
2 77 z's and on both of them the relay was rusted.
It seems they mount it upside down right under the
corner of the windshield. So it doesn't take much
water to corrode it.
Just my 2 pennies

Kelly
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top