Joined
·
13 Posts
I Have a 280z 76 and Im having a big problem. It wont start. I found that the fuel pump is not kicking on. I pulled off my starter to see if that was the prob. still no go. then i did the hole check out of the air flow meter. so then I ran a wire from my battery to it. It kicked on but I went to turn it over and i found that my injectors are not opening up.I replaced the fuel injection relay and I also shot the ohmes for the wire to the pump. the other thing I found was that the ground to my water temp sensor is not there also a few others. If some one can help me out with advice or even a good wiring diagram. that would help my email is [email protected]