ZCar Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
567 Posts
Discussion Starter · #1 ·
Is there a relatively simple way to do this? Would an aftermarket ignition help simplfy the situation? I want to put a modified zx engine in my 240, and I think FI is way better than any carb setup. I need input on anyone's previous experience or any advice you can offer. Thanx in advance.
Tony Rohn
 

·
Registered
Joined
·
107,695 Posts
so many wires, so little time

I hsve traced out the wiring to do this and it is a nightmare. 82 zxt engine is in the 260z and i am currently wiring it up. there are actualy only about five wires needed to wire up the harness and computer to the car harness. you also need a zxt fuel pump and and all of the other turbo support components (ignition, air flow meter, heat shields, etc). If you are interested in the untested wiring diagram then e-mail me. I am not visiting here too often and i have postponed further work on my car because it's boat season almost and my boat is still not running.
Z-on
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top