ZCar Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
335 Posts
Discussion Starter · #1 ·
I am going to put the front seal back in the car tomorrow.
does the seal go flush with the front case or is there a bit of a lip sticking out
I ask because the one I am replacing was sticking out just about a 1/16th of a inch. where the one on my l-24 motor was flush with the case.
any adviceas to instaling the puley woulk also be helpfull, I have a Haynes book and all but there is no substitute for someone who has done this ans not had a leak :)
Thanks for the help, I miss driving the car and the local economy is starting to feel the pinch of me not dumping endless amounts of cash into my z
 

·
Registered
Joined
·
107,695 Posts
<b>RE: front seal instalation help needed</b>

The front main seal should be flush. Use a piece of wood over the seal to hammer it in place. This will help you avoid denting or bending the seal. Should be a 5 minute job.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top