ZCar Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

· Registered
Joined
·
1,779 Posts
Many folks use ExtrudeHone for all-out racing...frankly, IMHO, it is too expensive for a street/daily driver...but for drags & etc and all the other major mods used too
then it might be worth the $$$$...what does your engine-builder say???... :eek:)
 

· Premium Member
Joined
·
41,285 Posts
Good Price!

Current listed 6 cyl alum intake jobber price is 385$.
Not "too expensive" in my book, especially if you get impatient for more HP...
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top