ZCar Forum banner

Status
Not open for further replies.
1 - 13 of 13 Posts

·
Registered
Joined
·
632 Posts
Discussion Starter #1
are the bends any different from a 86na to a 85T? this would be from the cat-back. the reason is i have my stock 86na exhaust in the garage and im wanting to order SS bends for my 85T, and use the old exhaust as a templete(sp?)
 

·
Registered
Joined
·
4,438 Posts
<http://www.certifiedmuffler.com>

But no. There shouldn't be any differences in the exhaust routing between the NA and the turbo from the cat and back.
 

·
Registered
Joined
·
586 Posts
"But no. There shouldn't be any differences in the exhaust routing between the NA and the turbo from the cat and back."

If that were so, why does Motorsport and others sell cat back systems that they say are for non-turbo only and others that are turbo only? Could it be that the cat conv is in a slightly different place on a NA vs a turbo?
 

·
Registered
Joined
·
1,454 Posts
turbo and na have the same bends in the piping but diff. diameter piping
 

·
Registered
Joined
·
4,438 Posts
111 CAT BACK W/ NO MUFFLER OR TIP = $170.00

Put any muffler you want on it, or slide a pipe about 20" long onto it and you're done. No cutting, measuring, bending, welding, etc required.
 
1 - 13 of 13 Posts
Status
Not open for further replies.
Top