ZCar Forum banner

Status
Not open for further replies.
1 - 8 of 8 Posts

·
Registered
Joined
·
68 Posts
Discussion Starter · #1 ·
I just got a 1985 300zx turbo. I am going to do a engine swap into a vw baja. It is already 12a rotary powered. I need wiring diagrams for this car. Does anyone have any they can send me or send me for good ones, thanks. [email protected]
 

·
Registered
Joined
·
68 Posts
Discussion Starter · #3 ·
I will be putting the rotary in a street car, then turbocharge it. I already have the z car and 5 other cars.
 

·
Registered
Joined
·
68 Posts
Discussion Starter · #8 ·
sorry its been a long time. I got the rotary turbocharged but had a hard time getting it to run. anyways I got the z engine in the baja. The wiring harness is almost 100% rebuilt. The motor is back in the car and it should be going in the next week or so.

I need to find a pulley for the alt with the same design as the pump and crank. the v belt wont work and I only wanna use one belt anyways. anyone have a idea how to do this?? just the alt and water pump is all I need.

http://i87.photobucket.com/albums/k146/mazda_6t9/DSC00007.jpg

hopefully the link works
 
1 - 8 of 8 Posts
Status
Not open for further replies.
Top