ZCar Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
253 Posts
Discussion Starter · #1 ·
The shop is a few weeks away from my engine rebuild and I am looking for comments and advice before the metal starts flying. I am having a 82 flattop mated with a p90 head. It is repalcing a 77 stock motor with 200,000 on it. What kind of improvement will I see in performance. Is there something I should have done that will improve on a basic rebuild. It is being balanced, bored to next piston size and the head is being rebuilt. Any comments or ideas will greatly appreciated.
Thanks in advance,
Jon
 

·
Registered
Joined
·
27 Posts
> The shop is a few weeks away from my engine
> rebuild and I am looking for comments and
> advice before the metal starts flying. I am
> having a 82 flattop mated with a p90 head.
> It is repalcing a 77 stock motor with
> 200,000 on it. What kind of improvement will
> I see in performance. Is there something I
> should have done that will improve on a
> basic rebuild. It is being balanced, bored
> to next piston size and the head is being
> rebuilt. Any comments or ideas will greatly
> appreciated.
> Thanks in advance,
> Jon
Use a N42 head it gives better compression ratio
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top