ZCar Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
35 Posts
Discussion Starter #1
I pulled my ECU out and tried to run codes. My inspection lights never came on nor did the blink. I am using the Haynes Manuel, but, it did not tell me what was wrong if the inspection lights don't work.

I did what the manuel said to do. I turn the screw counter clockwise, turned on the ignition and then turn the screw clockwise. Nothing!!!!

Something else strange starting now. The is a noise coming from something near my left (passenger head light). I had to get under the car to see it. It looks like a radiator or something. Now what?



Post Edited (Apr 14, 6:15pm)
 

·
Registered
Joined
·
880 Posts
hmm... take the ecu out, but leave the wires hooked to it, turn the key on, turn that little screw to clockwise, the lights should start blinkin telling you what mode you are in. when they lights blink 3 times, turn the screw back all the way.. then it should start giving you codes... i doubt the lights are broken.. good luck
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top