ZCar Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
1,710 Posts
Discussion Starter #1
well it seems like **** trying to get down there to the wastegate - what is he easiest way to go about hooking one up



Post Edited (Aug 15, 6:18pm)
 

·
Registered
Joined
·
154 Posts
there is a plastic plate that covers the bottem side of the motor, take that off and then it will be easyer, this is not that easy if you have large hands, i recomed a long plyers and a flat headed screw driver. and a good luck it is worth the task, and go to the hardware store and plug of the p.o.v. other wise it will not work. peace and have fun
 

·
Registered
Joined
·
1,710 Posts
Discussion Starter #3
ya i know i started to lat tonight from under the car and i dont have huge hands but there not small and it makes it pretty **** hard but ill do it tomorrowbecause i know its worth it

what do you plug the pop off valve with just get a ntp plug? or can u just jb weld the pop off valve or somethign stupid?
 

·
Registered
Joined
·
154 Posts
no i went to homedepot, i think it is a 1 in or 1 1/4 in metal plug for like 1 dollar, then get some seal tape and rap it before you put it in other wise there will be a leak.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top