ZCar Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
My 280zx won't start and I'm going through everything. I decided to check out the distributor timing for the spark plugs. I checked the wires and it was not in the correct firing order. From looking it up the firing order is 1-5-3-6-2-4, but how do I set this up on the distributor. Do I set the order in a clockwise direction on the distributor or counterclockwise? Or something completely different? I tried looking it up on the forms but I couldn't find a post that covered what I am looking for. Any help is greatly appreciated!
 

·
Registered
Joined
·
194 Posts
I’d check out the manual if you haven’t see this site.


I don’t know I if or others can help, but would help to give as much info as possible.

If you haven’t, go through and clean the engine harness sensor connectors and gently check the wires. The insulation on mine is pretty hard and will most likely crack if I were to mess with it to much.

Another good source of info here. 280 has almost exact same set up



Sent from my iPhone using Tapatalk
 
1 - 4 of 4 Posts
Top