ZCar Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
1,826 Posts
Discussion Starter #1
Took my rotors down today to have them turned, but couldn't find a spec stamped on them. The parts guy said .420 was the minimum, but they measured .340. A set I had on another car also measured that thin, so I figure the .420 must be wrong. What is the correct minimum?
greg
71 240z
 

·
Registered
Joined
·
107,695 Posts
My 71's rotors had a min thickness of 10.5 mm stamped into them. It sounds like yours are way to thin. 10.5 mm. is close to the thickness the parts store told you about.
Hope this helps
Sean Boyle
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top