ZCar Forum banner

Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
548 Posts
Discussion Starter #1
Just wondering if anyone has a sugestion on what type of sealer to use with a copper head gasket.
Thanks, Trey
 

·
Registered
Joined
·
432 Posts
Don't know if you got yours new or used. The only place I have seen (and I admit I have not looked very hard) is a place called Paeco. You might want to e-mail them and ask their advice.

I know you can get a high tack spray gasket sealer that has a copper base which I would think we be compatable. Most every auto parts place has it.

Charles
 

·
Registered
Joined
·
432 Posts
Yea, yo, the paeco is reuseable, man it oughta be for what it cost. I want to say it is like 200 or 250 but if it seals as well as they claim it would be a bargain for the high compression crowd. Also it comes in two thicknesses, .030 and .060. So a little over 1mm and a little over 2mm. Now that I think about it I believe the catalog says that as long as the deck and head are perfectly flat you need no sealer on it.

Charles
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top