ZCar Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
107,597 Posts
Discussion Starter · #1 ·
hey z friends
I have a problem and I figured that someone could help me out. I just replaced the transmission in my 83 280ZX 5 speed. I put a 4 speed in because it was really cheap(20 dollars) and in great condition. I'm really not very good at working on cars so I was happy when I finally got the transmission bolted back up. Well when I tried to start the car up to test out my handy work the car would not start. I can hear the fuel pump turn on so I don't believe that is it. I also tested the starter and it is ok. I don't understand this because before I pulled the old tranny the car would start up within 2 seconds even after sitting outside in 0 degree weather for 2 weeks. I really need to get this thing back on the road so any help would be greatly appreciated. sorry for the long post.

thanx

cole
 

·
Registered
Joined
·
107,597 Posts
Discussion Starter · #3 ·
> Check and make sure that the plugs are
> firing first. This may isolate it a bit. You
> may have knocked off a wire or something.
> Trying to retrace you steps may help too. I
> know this isn't much help, but it may get
> you started.

> K
You may not have supported the engine, and if you didn't, I would look at your afm boot, and see if the engine tilted back, and pulled it off. I have seen this happen a few times. Joe
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top