[ckillerh3]

Hi -

Just took my Cam Oiler off my L24 engine to clean it out. There were
some crusty gasket thingies there that fell apart upon cleaning. Can
I just botl the Cam Oiler back on, should I make a replacement gasket
(from paper gasket material) or can I buy replacements somewhere (I could not find them from Motorsport or Vicrotia British LTD).

Thanks a bunch !

 

[GrahamBCZ]

Just make some with gasket material and dont over tighten them.

 

[ckillerh3]

Hi -

Thanks for the reply. I made some from paper gasket material which I stuck
on with a little RTV gasket sticky stuff. I put them on and did not over tighten as you suggested. I made the holes a tiny bit bigger to make sure I did not clog
any of the inlets.

Again, thanks for the note !

Stephen Wagner