ZCar Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #1 ·
I have a 240 front bumper. I want to mount it on my 280, I know this has been done. Does anyone have some advise on how to remount this on to my frame? Thanks

Bean Bandit
 

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #2 ·
> I have a 240 front bumper. I want to mount
> it on my 280, I know this has been done.
> Does anyone have some advise on how to
> remount this on to my frame? Thanks

> Bean Bandit

I did this on my late model 260Z. Get the original 240 bumper mounts. Turn them backwards ( Tab in to the middle. You need to cut the the long side about 2 inches from the tab. remove your old bumper shocks. The long side of 240 bumper mount you cut will mount in two of the three hole. Angle it up in the front. mount the Tabs to you 240 bumper. Place the bumper in place, clamp the brackets together, remove and weld.

This is a little wordly and hope it helps.

Rick BSPZ
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top