ZCar Forum banner

"Breaking In" Re-Built Engine - Oil and Other Suggestions?

920 Views 6 Replies 5 Participants Last post by  JohnH
We will be re-building a turbo engine to swap into my 1983 280zx. After it's all back together, tuned up, etc., what are the proper / steps to break it in? Oil to use, oil change frequency for the first ________ miles, etc?
Status
Not open for further replies.
1 - 7 of 7 Posts
I don't know off the top of my head, but I'm sure it's in the FSM. :D
JGW006 said:
We will be re-building a turbo engine to swap into my 1983 280zx. After it's all back together, tuned up, etc., what are the proper / steps to break it in? Oil to use, oil change frequency for the first ________ miles, etc?
Check out datsunzgarage.com, then under cylinder head time line. Looks to be a lot of good information on rebuilding a engine etc.
rednekz said:
I don't know off the top of my head, but I'm sure it's in the FSM. :D
OK, I've learned to go to FSM to look up service things, but for some reason didn't think about looking there for a break in regimen. Point made!
JGW006 said:
rednekz said:
I don't know off the top of my head, but I'm sure it's in the FSM. :D
OK, I've learned to go to FSM to look up service things, but for some reason didn't think about looking there for a break in regimen. Point made!
Let me know the exact section & page you find a rebuilt engine break in routine in the FSM that specifically states actions to take for "break in" only.
Wouldn't the normal driver's manual have a section that talks about break-in? Because the normal person who purchased the vehicle new would need to know such info...
Sidney5101 said:
Wouldn't the normal driver's manual have a section that talks about break-in? Because the normal person who purchased the vehicle new would need to know such info...
We have a winner.

Page 30 of owners manual

http://xenons130.com/files/ownersmanuals/1983280ZX.pdf
1 - 7 of 7 Posts
Status
Not open for further replies.
Top