ZCar Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #1 ·
Allright, this was my first time changing the barkes on my 73. It wasn't as bad as I thought except for one thing:

I cannot get the metal clips that hold the pads together to fit! This is probably due to the fact that my rotors are brand new and pads are also brand new. The thickness does not allow for the clip any clearance to fit back in. In the meantime, I did not install these clips and wait for the pads to settle down; then maybe the clips will fit. Anyone experience this?

Eric's 73 project:
www.geocities.com/~esanmiguel/projz
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top