ZCar Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #1 ·
Nothing happens when I turn the fan switch on for heat or air. The fuses are fine. How much and how hard is a blower motor to install?
 

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #2 ·
> Nothing happens when I turn the fan switch
> on for heat or air. The fuses are fine. How
> much and how hard is a blower motor to
> install?
Blower motors aren't hard to install, 3 screws to get the molding and vents out, 1 screw in a relay you have to move and 3 screws holding in the motor. I would check a few things before you go and replace the motor. First did you check the fuse that is on the motor itself, next make sure the motor is getting power check the L shaped connector going into the motor with a volt meter or test lamp. If you are not getting power and you're absolutly sure the fuse on the motor is good your problem is most likely the blower amplifier (it's the funny looking box about 1.5X2 by the blower motor it should have 4 wire going into it) Next pull the motor out of the car and make sure it spins freely, then using a couple of jumpers connect it directly to the battery. Hope that helps, email me if you have any questions.

Jared
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top