ZCar Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #1 ·
Can any one tell me the best procedure to remove the ball joints on an 82 280ZXT w/ power steering. The Haynes manual says that you should remove the entire transverse link, and then pull the ball joint off. Is this the only way or can it be a little easier than that. Please tell me what special tools I need. Any help would be greatly appreciated.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top