ZCar Forum banner
Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #2 ·
RE: What the Fac, Fac!

Thanks for the advice you gave me, i wish i can figure out my exact compression ration though i'am always leary to step on it. sence i've be told to watch detination . I let you know whats going on with it.
Thanks again
Fac1973
 

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #3 ·
<b>RE: What the Fac, Fac!</b>

I can tell you how to figure out the compression ratio. If you need the formula, let me know.... to do it, you need to know what you have. Block casting number, piston type, head gasket thickness and head casting number. If the head has been shaved, how much?

Let me know when all this information is gathered.

Dennis
 

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #5 ·
<b>RE: What the Fac, Fac!</b>

I'll do ya one better.... I didn't write this but let me direct you to a place where its explained very well. If you have any problems let me know and I can help. I have a CS degree from CAL-Berkerley. So this is childs play for me... I'll also write a short blurb as another topic to help anyone that needs the help.

Go to http://geocities.com/MotorCity/Track/6997/compression.html.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top