ZCar Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #1 ·
how do I pull these out of the diff. Do they come out easily, the manuel just says pull it out but it is never that easy. Thanks Guys Jeff
 

·
Registered
Joined
·
1,826 Posts
RE: just yank it

You just have to pull them out. usually takes a good yank and they will pop off. You can try a crowbar, but be sure not to damage the dust cover for the seals. Easier if the whole rear is out of the car. try compressing the halfshaft first, then yanking. Good luck
greg
71 240z
 

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #3 ·
<b>RE: just yank it</b>

this job is somewhat hard but the easiest way is to lock up the back breaks and using a 14 mm wrench (that is the closed end) break them loose. if you have room use a small pipe at the end to ease the stress . after all the nuts are off use a small flat object to tape the screws in so that theres more room. as for the half shafts you can either
tap them with a hammer using a block of wood between them i hope this helps
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top