ZCar Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
171 Posts
Discussion Starter #1
is there a place on the exhaust manifold to connect the autometer boost gauge with the 1/4 or 1/8 npt adapters? is there a better way to install? thanks for any info.
-cary280zxt
 

·
Registered
Joined
·
67 Posts
I have not used an autometer guage on my 280zxt, just a pressure guage. What I did was put a T fitting in front of the factory sending unit that is mounted on the left side of the engine compartment. Using 1/8 " rubber hose i ran the line into the drivers side. this allows for the use of the factory unit also. I used safety wire to make a clamp on each connection so that the pressure will not blow the hose off. Ihope this info. helps.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top