ZCar Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
662 Posts
Discussion Starter #1
I need help!

I cant stand my Z being an auto any longer!

I've got all the bits I need to do the swap except whatever sits between the flywheel and the engine.
I've been told over here in the UK that I need a Spigot Bearing !?!?
I've been told on this forum that I need a Pilot bushing!?!?
So i went to my local Nissan dealer and asked them to get me whatever is in between the flywheel and the engine...
They got me a small brass tube, part number 32202-7F401.
This cant be all I need...

Does anyone have any pics of a pilot bushe / bearing or even a part number?

Thanks for your help,

Matt
 

·
Registered
Joined
·
321 Posts
That is the piece. It goes right over the center shaft of the transmission on the engine side. Basically a spacer for that shaft and the crank to keep it centered. You will either have to remove the bushing in the crank for the automatic or some people have drilled it out to get the bushing to fit for the 5 speed.
 

·
Registered
Joined
·
662 Posts
Discussion Starter #3
Thanks,
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top