ZCar Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
107,597 Posts
As far as the ticking is concerned, I have heard some Z's that hardly make a sound and others that are clattering away like a diesel. Even though both had the valves adjusted by the same guy. I'm hoping it's the lash pads (bcause I just replaced mine) but maybe someone here has the actual answer!

Steve Graber

The link to the intake is <A HREF=http://www.newtier.com/graber/z-car/Air-Intake-Project/index.html>http://www.newtier.com/graber/z-car/Air-Intake-Project/index.html</A>

Note: The part # for the K&N filter is actually RU-900.
 

·
Registered
Joined
·
107,597 Posts
K&N mods

I like Steve's setup a lot. But.. Being lazy at times I used 2 1/2 PVC with the female ends in a 90 degree and a male/female 45 degree. The outside diameter for this is 2 3/4 and will slip right into the AFM rubber bellows and also inside the K&N RU-0900. Mine is more restrictive than Steves setup primarily but still helped a bit response. You can hear it sucking air with the hood open. If you use this method make sure the filter clears the hood and hinges as it is close to the original filters location. Cost? Under $30.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top