ZCar Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
261 Posts
Discussion Starter #1
There I was, happily adjusting my drivers side door handle, cleaning out the drainage channels and oiling the sliders for the window and without warning the window doesn't wind up. The handle turns but the freakin' regulator doesn't move at all!! And it's holiday time!!

Just wondering if anyone has successfully repaired the regulator or knows what other Datsun regulator will fit - can't get hold of junkyard 240's where I am.

Any help much appreciated.

Thanks,

Ian
 

·
Registered
Joined
·
2,676 Posts
The teeth are probably stripped on the quadrant. I welded one and cut new teeth into it with a die grinder but it didn't last long. Try and find a decent used one. I believe they are the same in the 260 and 280s.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top