ZCar Forum banner

Status
Not open for further replies.
1 - 13 of 13 Posts

·
Registered
Joined
·
1,991 Posts
Discussion Starter #1
Need to finish the welds, but this is where the wastegate has ended up. As we all know space is not on our side under the hood on these. But.. the gate has very nice flow thru and out , right back into the flow of the 3 inch Down pipe. This is been the most difficult part of this project, but the light is seen!
After the pipes are completed, it to the ceramic coating shop, and then it goes on the car. This peice is within 7.5 inches from motor, and from all the measuring, it should fit nice. I HOPE SO.................









 

·
Registered
Joined
·
373 Posts
looks sweet but I would replace the water pump by the looks of the spindle its due . But that is going to be one sweet ride to steal the line used above . LOL
 

·
Registered
Joined
·
782 Posts
Your a fabricating fool. I think it will fit but I think it will only clear the sides of the engine bay by like a 1/4 inch it will be a tight fit. Is that the engine your going to use or is that just a dummy engine for the pipe layout?
 

·
Registered
Joined
·
662 Posts
Nice-Nice-Nice
 
1 - 13 of 13 Posts
Status
Not open for further replies.
Top