ZCar Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
1,078 Posts
Discussion Starter #1
Hi all,

Hope you've all had a good thanks giving.

I posted a while back here regarding problems getting into reverse and 1st on my 73 240Z, a few of you suggested that the clutch may need adjusting.

I've never adjusted a clutch before, I've read up on it in the Haynes manual but would appreciate any pointers and info on anything I need to be aware of before I start.

Thanks all

Jules
 

·
Registered
Joined
·
830 Posts
First thing I always do is bleed the clutch at the slave. Then there is a nut on the slave piston that can be adjusted. The whole thing should take about 15 minutes.

Chrome
 

·
Registered
Joined
·
1,153 Posts
If the slave adjustment does not bring it in line, you can also adjust the clutch pedal. Start with the bleeding and flush, though.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top