ZCar Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

· Registered
Joined
·
107,597 Posts
Discussion Starter · #1 ·
Ok, so far this board is great, and now i have a few questions
1. anyone know of a good place around the cental coast area of cali to get info or parts
2. how diffuclt is it to replace a clutch and tranny with all the right tools, 78 280Z 5speed
3. anywhere online or any catalogs i can order to look at high performance parts for my Z.

well thanks alot
BW

Password:
 

· Registered
Joined
·
107,597 Posts
Discussion Starter · #2 ·
> Ok, so far this board is great, and now i
> have a few questions
> 1. anyone know of a good place around the
> cental coast area of cali to get info or
> parts
> 2. how diffuclt is it to replace a clutch
> and tranny with all the right tools, 78 280Z
> 5speed
> 3. anywhere online or any catalogs i can
> order to look at high performance parts for
> my Z.

> well thanks alot
> BW

> Password:

Replacing the clutch and transmission is not very hard. I did it with no experience at all. It wasn't on a Z though. But probably about the same since it was a Datsun 210. You need a clutch alignment tool for putting the new clutch in and will have to bleed the clutch hydralic line when finished. The same as bleeding the brakes.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top