ZCar Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
So I just bought this 5 speed swapped 85 z31. Clutch pedal was only at the halfway mark and would only engage basically at the floor mark. A few days later it finally gave it out.

So I replaced the slave cylinder, master cylinder and bench bleed the master. Removed the damper and hardwire a braided hose from the master to slave. I have been pumping and pumping my pedal with no pressure building up at all.
What do I need to do? Then even if I do pump it up and hold it down. I go an release the bleeder nipple on the slave and fluid only trickles out with no air.
 

·
Registered
Joined
·
174 Posts
It sounds like you are trying to do this alone. Bleeding a brake or clutch is a two person operation.

The FSM has good description of the procedure. (CL section)

If you do not have the Factory Service Manual (FSM), try this link. Xenon is a great reference site, bookmark it.
 
1 - 2 of 2 Posts
Top