ZCar Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
381 Posts
Discussion Starter · #1 ·
Here's my problem. I'm not getting any boost or at least it makes no difference when I manipulate the wastegate
on the Turbo. Anyway My manual says the wastegate
stroke distance should be .38mm but I found that the
wastegate on my turbo stroke is .5 inches or more; Is my wastegate broken?
I thank you for any and all suggestions.
Tom
 

·
Registered
Joined
·
111 Posts
MAKE SURE THE WASTEGATE IS COMPLEATLY
CLOSED CHECK BOOST PRESSURE USE A GUAGE
CONNECED B4 THE BOOST SENSOR
IF YOU ARE USING STOCK BOOST GUAGE TO CHECK YOUR TURBO IT SHOULD GO INTO RED ZONE WITHIN 1 SEC. IF YOU FLOOR IT FROM 3K RPM
GOOD LUCK
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top