ZCar Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #1 ·
I own a '80 ZX, car will not drop in RPM on deceleration, stays at 2500rpm,will drop when I tap the gas,
linkage looks fine...
any ideas?
 

·
Registered
Joined
·
107,695 Posts
Discussion Starter · #2 ·
I think you are on track with the BCDD. You can safely remove this device and block it off with a sheet of gasket material. Then bolt it back on for that "stock" look. It's just 3 screws from the bottom.

Steve
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top