ZCar Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
107,695 Posts
Discussion Starter #1
I have a 1979 280ZX (Canadian Car) and for a long time the Temp Gauge has been acting up and going clear over to hot past the 130 degree C mark. Yesterday I changed the sending unit on the block and today it stays there all of the time. HELP!...Suggestions would be appreciated. I used to own a shop manual for it, but it got swiped. does anyone know if the wire from the sending unit goes straight to the gauge or somewhere else first. Without taking the whole wireing harness loose. Ray B.
 

·
Registered
Joined
·
107,695 Posts
Discussion Starter #3
> Could be a bad gauge..they do fail
> sometimes.

Thanks for you response Bob.
If the gauge is bad, why would it have worked part time before.
Where would be the best place to get a gauge that reads Metric. I live in Washington state.
How hard is it to change the gauge would I have to take the hole dash apart.
Thanks Again,
Ray
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top